"Look Ma! No wires!"

With standard manual radio slaves - purchasing the transmitter is just the start. Then you've got to figure out which cords and adaptors are required for your particular hardware, and cringe at the markup on these accessories.

The RadioPopper P1 has no wires. None. Zip. We left out the connectors, adaptors, and converters while we were at it.

The only accessories required to get your P1 system running are a couple squares of Velcro to hold them to your flash - and we've even included those for you.

The P1 Transmitter sits on the top of your Master flash device and actually picks up the magnetic "static" put off by the electronics inside the flash right through the plastic. It then uses these signals to control the radio transmitter to "reproduce" the signals in the P1 Receiver.

The P1 Receiver has a simple output. An internal light source creates the "reproduced" light signal which is sent down a flexible fiber-optic tube which lights a nylon bead at the end. This bead is simply taped over the infrared sensor on your slave flash normally used to "see" the signal from the master.

It really is just that simple, and we're not even kidding.

<< Back